Home › Forums › Vinyl Cutter Discussions › Roland Cutters › Print, Laminate and Cut on Sp300

  • Roland Cutters

    Print, Laminate and Cut on Sp300

    Posted by Ameer nurmahomed on 24 November 2016 at 14:12

    Hi

    I just wanted advice on how I would go about printing vinyl, laminating and then contour cutting over the laminated print on a Roland SP300.

    How would the process work?

    Any suggestions would be great.

    Thanks in advance.

    Joe Wigzell replied 8 years, 10 months ago 1 Member · 1 Reply
  • 1 Reply

  • Joe Wigzell

    Member
    25 November 2016 at 11:06

    $this->BBvideo_pass(‘$8’, ‘$4’, ‘$7’)

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .