Home › Forums › Printing Discussions › Roland Printers › Powercut Help

  • Roland Printers

    Powercut Help

    Posted by Paul Seamer on 10 December 2008 at 13:07

    Hi Guys,

    Just had a powercut at the unit and have popped home as there is nothing to do and can’t see. I have a Roland SP300 which has obviously off. Will this damage the machine. Is there anything I need to do when the power comes back on?

    Please help 🙁

    Paul

    Alan Drury replied 16 years, 11 months ago 3 Members · 3 Replies
  • 3 Replies

  • Richard Urquhart

    Member
    10 December 2008 at 13:42

    I would say it will be fine up to 12 hours off, just run a print of when its back on
    Rich

  • Paul Seamer

    Member
    10 December 2008 at 14:21

    Hi Rich,

    Thanks for the reply. Power came back on about an hour later so should be OK. Got back to working again then it went again for 2 mins. Not panicking to much now but preying that it doesn’t go again after work.

    Paul

  • Alan Drury

    Member
    11 December 2008 at 09:04

    Have you thought about an UPS supply, mine was only about £30.00, it cuts in as soon as there is loss of power and gives me about 15minutes to turn everything off properly. Large units can service more machines or last longer.
    Alan D

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .