-
Out door signage
Afternoon all on this lovely sunny day 🙂
I am looking for abit of advice we have had a customer asked for some out door signage, they are looking for 5ft x 4ft sign on 2 posts.
I was wondering what the best way to join the sign to posts as i dont like the look of bolts through sign if i can do different way, does some make a system that i can buy including posts and dibond board and fixings.
from the top of the sign to ground level it needs to be 11ft so also what depth is best to be concreated in ?
Sorry for all the questions but we have never done signage like this and want to get it right.
Thanks jay
-
2 Replies
-
If you don’t want bolts through the face of the sign you’d probably want some Channel and Clips to attach the board to the posts. You can use VHB tape, but I’d still rivet it as a backup.
Look on the toolbar there’s a few suppliers of channel and posts.
-
Thanks for the reply
Like i say this is something we do not do very often, i just like to try and give every job 110 percent to make it the best it can be.
I will look on the toolbar.
Thanks jay
Log in to reply.