-
New Member
Hi all
Just joined up. I do sublimation printing but will soon be purchasing a 24in. cutter to cut polyester flock for printing.
Cheers
Jim -
12 Replies
-
Hi and welcome Jim 😀
Venturing into the world of plotters eh? 😛 Careful, its sent most of us around the bend 😉 Seriously though, hope you enjoy the boards and look forward to hearing your progress when you grab your new machine 😀
Cheers, Dewi
-
hi jim
welcome to the site.. many newbies on the boards over the last couple of weeks so dont be afraid to jump in when you feel like it..we have a great bunch on the boards.. im sure you will fit in just fine 😉
if you would like your picture along with each post you make feel free to email it to me and i will load it for you.
-
hi jim and welcome!! 😆
good luck with your cutter, best place to be if you have any questions!!
Nik
-
Hello Jim.
Subliminal messages eh?
I hear em all the time!
(just kidding)
Welcome aboard!
Love…JILL 😉 -
Good grief 4 replies in as many minutes. I need advice on which 24in cutter to go for (Should this question be in another folder?) I hasten to add that I am 100 percent inexperienced in this field.
Cheers
Jim -
feel free to also post in the cutters forum mate..
-
Hi there Jim
Welcome aboard.
No doubt one of the “old hands” will comment regarding plotter recommendations. I use Roland gear – it’s been good for me.
I started off less than 4 years ago, so I consider myself a novice too!
Kind regards
Alan
-
another Welcome from me too Jim. As others have said, just ask away, we’re only to happy to help if we can 😀
Nigel
-
Jill’s been hearing voices again…I’m jealous. They said they only talk to me and me alone.
Welcome to the site Jim. Buy the best plotter you can afford but try to think of the future a bit…Will signage be part of your future? If so then 24″ might be a bit too small. just a thought.
Lee
-
Hi Lee
I’ll not be doing signage as such, Too many around me doing it. More of an addition to sublimation. looking for more specialised market. 24in. would be adequate. The question is, which cutter?
Cheers
Jim -
having had literally 3 months experience, a reply from me is probably not worthy of much credit! However, I bought a roland 24inch cutter and i have been very pleased with both the cutter and the service i have received from roland. They even provided a fantastic days training for free when I made the purchase. Good luck. Nelijane
-
Hi Jim and Welcome
A poll was done on the boards which show that good majority use 24″ plotters.
Handling 610mm rolls is a lot easier than 1220mm especially if youy have to do a Joseph’s coat of many colours job!! 😆
I’ve a Graphtec CE1000-60 which has done me well but of course there are others.
John 😀
Log in to reply.