-
Motor Error prob on a VP 540
Hi all,
I’m pulling my hair out on this one. I’ve a VP540, about 2 yrs old and pretty hard worked. I’m getting motor error messages (think the code is 0040) and it’ll request to be switched off. The weird thing is it’ll only do it when it is printing registration marks – either at the start of a print or, more frustratingly, right and the ****ing end! (hot)
Can anyone offer some advice? Also can anyone recommend an engineer in or around the Glasgow area? Printer could probably do with a once over.
Thanks folks.
-
4 Replies
-
Nick, if using versaworks when was the last firmware update you did? try updating the latest version, might be your trouble 😕
-
As Martin says needs to be firmware 3.1 or above
Kev
-
Thanks guys, downloaded the latest from Roland and I’ll see how I get on with it. Should be running some more stuff off early morning so fingers crossed!
-
Seems to have done the trick – thanks guys!
Log in to reply.