Home Forums Software Discussions General Software Topics mistral12.03 someone please help!!!

  • mistral12.03 someone please help!!!

    Posted by James Stone on 3 March 2009 at 12:47

    Hi ALL,
    I’m a newbie on here so please bare with me.

    I’m running a mistral rip software with a jetster 62 but i’m struggling with it.
    I have installed the software and profiles and the printer is running test prints fine but for some reason the printer isn’t printing anything when I tell it to??

    Is it just me or am I doing something wrong on the setting up??

    Can someone please help

    Cheers James

    James Stone replied 16 years, 6 months ago 3 Members · 3 Replies
  • 3 Replies
  • John Harding

    Member
    3 March 2009 at 16:58

    Hi James

    I havent got a clue how to solve your problem, someone will no doubt. However if your next post is in the say hello section I reckon you’ll get a good response a lot sooner 😀 😀

    Good luck – John

  • Fred McLean

    Member
    3 March 2009 at 17:19

    Hi James, Have you got Mistral sending to the same IP address as the printer should be set to??
    We’ve a jetster 46 running Mistral so i assume would be the same menus etc. etc.

  • James Stone

    Member
    18 March 2009 at 12:50

    Hi Fred,
    Sorry to be a pain yet again but i’m still struggling with this bit of kit.
    Let me tell you where I am with it so you can have a better understanding.

    The jetster 62 is manually printing it’s nozzle checks etc and the mistral rip is loaded but I really don’t know where to go from here?

    Do I need special cables or printer drivers??? I JUST DON’T KNOW….AAGGHH!!!

    You mentioned the IP address being the same as the printer?
    How do I change them to be the same???

    and what do I do from there???
    I’m so confused with it all!!!!

    Sorry to be a pain but can you help

Log in to reply.