-
Mimaki JV3 and Shriaz 6.4 colour problem.
Hi All,
I’m looking too print some green squares for a customer. The shade of green isn’t quite solid and there is a black number in the middle.
Using the correct profile is comes out washy and faded.
I set the force black and pure blend and it works fine and comes out how it should.
When I nest the job as a have a varied quantity it stops the force black and pure blend settings even though they are ticked.
I could out put the job not nested but would waste alot of media
Any thoughts
Cheers
Adam -
3 Replies
-
Dont know Adam, don’t play about with it that much.. i pass this on to AIT
-
Cheers Dave,
-
Try a different profile we were using a hexis vinyl and the proile was way off to the image so tried a banner profile and for some reason this works it was the dixons 2 sided 720 profile on the vinyl it matches very closely whats on screen.
If you have no joy with AIT try GPT most of the guys there used to work for AIT so know the shiraz backwards.
Log in to reply.