Home › Forums › Printing Discussions › Roland Printers › measuring media

  • Roland Printers

    measuring media

    Posted by Michael Tremarco on 23 August 2007 at 13:43

    Hello 🙂
    I change the media roll size in my Sp540 but the printer reads them wrong. I have just put a 500mm vinyl in and it is reading 350mm. I have moved the media clamps as shown by the guide but the arm only goes about 4/5ths along then returns and gives me the 350mm measurement. Even when I first changed the roll after installation to try other media, when I put the original roll back it read it shorter than it first stated .
    I think that you can override the unit with versaworks, but why is the unit not reading the correct media width? Any help will be most appreciated
    Cheers

    Michael Tremarco replied 18 years, 2 months ago 2 Members · 2 Replies
  • 2 Replies

  • Gary Birch

    Member
    23 August 2007 at 14:04

    Hi Michael
    I think you will find it is the outer most rollers it measures to and not your media clamps. Try moving your rollers.

    Cheers

    Gary

  • Michael Tremarco

    Member
    23 August 2007 at 14:19

    Gary
    Thanks so much mate 😀

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .