Activity Feed › Forums › Vinyl Cutter Discussions › General Cutter topics › MC270, Minicut blade height how to adjust?

  • General Cutter topics

    MC270, Minicut blade height how to adjust?

    Posted by ccheater on August 31, 2006 at 8:43 pm

    Whats the best way to set the blade height on Minicut? It keeps tearing the vinyl at the moment or not cutting quite deep enough is there a trick to getting it right?

    thanks for any help

    ccheater replied 17 years, 10 months ago 2 Members · 2 Replies
  • 2 Replies

  • Peter Normington

    Member
    August 31, 2006 at 8:59 pm

    No idea about a minicut, but if the blade can be adjusted in the holder, most plotters just need the blade to protrude slightly more than the thickness of the vinyl, so its not much, I hold mine up to the light to adjust, If you can just catch the reflection of the point of the blade its about right.

    Peter

  • ccheater

    Member
    August 31, 2006 at 9:06 pm

    Thanks, think I need to practice!!

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .