Home › Forums › Sign Making Discussions › General Sign Topics › Laminator grippers – where to source?

  • General Sign Topics

    Laminator grippers – where to source?

    Posted by MikeGrant on 13 March 2014 at 10:59

    Just wondered if anyone knew where I could source a pair of secondhand core grippers?

    They’re for a GMP laminator, though I’m sure grips from some other make might suit.

    Size: they are for a 75mm inside diameter core, and the hex rod they fit on is 20mm thick.

    Image attached.

    Attachments:

    Cheryl Smith replied 11 years, 9 months ago 1 Member · 1 Reply
  • 1 Reply

  • Cheryl Smith

    Member
    13 March 2014 at 16:36

    You could always try Harry at Edward Mathias
    01928 739799

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .