Home › Forums › Printing Discussions › General Printing Topics › Laminator advice needed

  • General Printing Topics

    Laminator advice needed

    Posted by Andrew Fleming on 13 October 2008 at 15:35

    Looking for some guidance on a Laminator, we do the usual signage bits but are looking to putting in a large 1370 inkjet printer and was wondering what is the best way to go, hot/cold etc etc.

    Thanks in advance.

    Jon Marshall replied 17 years ago 1 Member · 1 Reply
  • 1 Reply

  • Jon Marshall

    Member
    13 October 2008 at 15:40

    Usually heat assist, i.e. one roller is heated.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .