Home › Forums › Printing Discussions › Mimaki Printers › JV3 blown slider board?

  • Mimaki Printers

    JV3 blown slider board?

    Posted by John Thomson on 13 December 2013 at 08:06

    Hi,

    yesterday half of my nozzle check on the magenta head in my Mimaki JV3 dissapeared completely.
    I left the heads soaking overnight and same result this morning.

    Am I correct in thinking the slider board has blown?

    Thanks

    John

    Stafford Cox replied 11 years, 10 months ago 3 Members · 3 Replies
  • 3 Replies

  • Vic Adair

    Member
    13 December 2013 at 08:21

    Have you checked that one of the carts isn’t empty? Iv’e pushed it forward before +30 and its already been pushed before and the ink ran out

  • John Thomson

    Member
    13 December 2013 at 12:21

    after a bit of investigation there was an air bubble in the line……….ink fill moved it and test print is perfect again 😀

    Happy not to have needed to buy a slider board!

    John

  • Stafford Cox

    Member
    13 December 2013 at 16:32

    In my experience, when a slider board goes, it affects both of the same colour (i.e both magentas would either not fire at all or fire all the time) rather than just one side.

    Glad you sorted it out anyway.

    Stafford

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .