Home › Forums › Vinyl Cutter Discussions › General Cutter topics › Jaguar II 61 Plotter .. USB Connection

  • General Cutter topics

    Jaguar II 61 Plotter .. USB Connection

    Posted by Adrian Neill on 17 April 2008 at 13:03

    We need to use this plotter temporarily.

    We’ve connected it via a USB cable, and are trying to run it from Omega V2.5.
    We seem to have set the settings ok on Omega, but there are many
    different languages the plotter can ‘speak’. Do we have to change one
    of these languages to enable the plotter to work ?? If it does, I don’t
    suppose anyone knows what one it is.

    Thank you once again. 😀

    Mark Elvidge replied 17 years, 5 months ago 1 Member · 1 Reply
  • 1 Reply

  • Mark Elvidge

    Member
    17 April 2008 at 14:08

    does omega give any options?

    "usually" default HPGL is a good get out of jail but unsure with these newer usb cutters.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .