-
Is there a setting to cure this
I keep getting these uncut areas on curved lines, is there a setting to cure this or have i bought a shite cutter? Its a Goldcut cutter.[/img]
Attachments:
-
5 Replies
-
If those two areas are the start and finish point of the cut then if would be the blade offset is incorrect.
Nigel
-
quote Nigel Pugh:If those two areas are the start and finish point of the cut then if would be the blade offset is incorrect.Nigel
Thanks Nigel, but do i increase or decrease that setting?
-
As nigel says……blade offset and also overcut…………..these will be set in your software.
John
-
Does any one know how to put a overcut on a roland gx24 cutting from corel please
stu -
quote Clive.Griffiths:quote Nigel Pugh:If those two areas are the start and finish point of the cut then if would be the blade offset is incorrect.
Nigel
Thanks Nigel, but do i increase or decrease that setting?
Clive the offset is too low so increase, you will get an over cut if the offset is too high.
Nigel
Log in to reply.