Home › Forums › Sign Making Discussions › Neon, LED, Lighting › how do you seal di-bond edges after cutting?

  • Neon, LED, Lighting

    how do you seal di-bond edges after cutting?

    Posted by Darrell Wootton on 24 October 2005 at 20:58

    Hi,

    I am looking for advice on dibond edges after they have been cut to size.

    How would you seal the edges after cutting when it is for outdoor use or is it not necassary to seal?

    I am concerned about water getting into the sandwiched material and causing any expansion and splitting.

    Thanks in advance

    Daz……

    Alcan Composites replied 19 years, 10 months ago 3 Members · 3 Replies
  • 3 Replies

  • Robert Lambie

    Member
    24 October 2005 at 21:17

    no need to seal it at all mate….

  • Darrell Wootton

    Member
    24 October 2005 at 21:39

    Thanks for the reply,

    I assumed it might be OK, but better to be safe than sorry.

    Daz…..

  • Alcan Composites

    Member
    15 November 2005 at 13:30

    Dear Daz

    As stated before the material is laminated in a way that ensures that it is suitable for longterm exertior usage without the need for ‘edge’ sealing.

    Regards

    Simon

    (mod-edit) no advertising, please see board rules

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .