-
how do i finish the edges of di-bond for a neat finish?
Hi All, I have a customer who wants a 4 sided suspended sign, i am thinking of folding dibond to make the open ended cube but does anyone have ideas of how to finish the last edge? to make a neat finish? I hope this makes sense 😕
here’s hoping
George
-
2 Replies
-
hi
there is a post on here by Richard Urquhart showing close up pictures of this, but cant seem to find it? not the one showing the orange tray, it was much closer up than that.
anyway you can use araldite or similar, key bothe surfaces then apply some tape to the outside of the joint to prent seepage. then apply glue and allow to set, if you have routed and cut it right you should have a pretty neat joint however you can give it a touch of paint on the join
hope that helps
dtg
-
yep, dtg is right, try demo section and show us your stuff for richies demo.. 😉
Log in to reply.