Home › Forums › Vinyl Cutter Discussions › Mimaki Cutters › Hemming Creases from Down Under!

  • Mimaki Cutters

    Hemming Creases from Down Under!

    Posted by Darlene Johnson on 16 December 2008 at 19:04

    Is there a setting in the JV33130 printer to print eyelets for the grommets? Or is this something I have to manual put into the pdf file?

    Advise… Thanks!

    David Rowland replied 17 years ago 2 Members · 2 Replies
  • 2 Replies

  • Robert Lambie

    Member
    16 December 2008 at 22:55

    i could be wrong but i have never heard of the software auto-applying marks for placing eyelets. would be a handy feature to have i think… but the settings would need to be pretty custom because you would need to be able to increase/decrease amount. depth into banner, spacing etc

  • David Rowland

    Member
    16 December 2008 at 23:17

    hm… actually i did my own version but I have seen it in the Cladera RIP, will do eyelets oddly as it may seem.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .