-
Hello from Slough, Berkshire
Hi Guys, very new to this industry, have been doing t-shirt printing using normal transfers and alot of Flex. Very small but functional machines (Sprint Heat Press and Graphtec CE5000-40 cutter.
I am going to try my hand at Vehicle Sign Writing, got the vinyls and everything needed to do my first BASIC job, only got a very basic software package that i was using for my t-shirt stuff (Magicut, was supplied by the people brought the equipment from).
Gonna need some advise on what software to get next, budget is about £200ish.
Have had a look around the sight and can already tell there is a wealth of priceless information and tutorial’s, hence i have applied for the gold membership.
Look forward to spending more time here and learning from the professionals.
-
7 Replies
-
Hi Raj, welcome to the forum. You would be better off asking any questions you have in a separate post in the relevant section. You will get far more answers that way as not everyone reads all the different forum sections.
Just to start you off though there are a lot of people on the forum that use corel and although I don’t use it myself believe it would be a good starting point for you. Is there any design software that you already have or are familiar with other than magicut as that saves the problems of having to learn a new software suit.
-
welcome to the boards raj 😀
nik
-
welcome to the boards, good to have you here… 😀
-
Hello and Welcome
-
Hiya Raj. 😀
-
Hi Raj – welcome 😀
-
welcome Raj 😀
Log in to reply.
