Home › Forums › Vinyl Cutter Discussions › Roland Cutters › Heater Timed Out error – RS640

  • Roland Cutters

    Heater Timed Out error – RS640

    Posted by David Hammond on 10 February 2012 at 13:56

    Just gone to print a small run (50) stickers, and the printers beeping away showing the error

    Heater Timed Out – Continue?

    I’ve never seen this before, is something on it’s way out? or is it just cold?

    I’ve reduced the drier temperature and it’s happy to print

    David Hammond replied 13 years, 8 months ago 2 Members · 2 Replies
  • 2 Replies

  • David Rowland

    Member
    10 February 2012 at 15:09

    the HP gave a similar error recently, the room was freezing!

    basically couldn’t reach the tempreture in pre-set time.

  • David Hammond

    Member
    10 February 2012 at 15:14

    Phew… I was panicing!

    It is bloody cold in here!

    Cheers Dave

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .