-
Greetings from Plymouth
Hi everyone.
A quick hello, from Plymouth, I just joined the forum hoping to pick up some tips and learn a bit about milling & engraving. I know nothing at the moment !
I bought a small CNC machine 200mm x 300m and Aspire software, as a hobby, very small home business. More for mind therapy than profit. I have restricted mobility from a car accident which leads to periods of depression, but I need to keep my mind active. Always look on the bright side of life …tee dum tee dum ..as the song goes 🙂
Hopefully I can produce signs & plaques as an addition to some wall plaque latex moulds I have for casting green men & other garden plaques from cement & water proof plaster. I did have lots of other larger moulds for garden ornaments but had to sell them, mixing large amounts of cement caused more problems with my back/mobility.
Hopefully milling & engraving will be less physical and more enjoyable.
-
7 Replies
-
welcome to the boards roy, good to have you here mate…
a bit of advice, please keep discussion of products etc to relevant forum. you will get more response this way mate.
-
Hi Roy,and welcome to the boards. 🙂
-
Hi Roy – welcome to UKSB 🙂
-
Welcome to the forum Roy, Aspire is an expensive program to buy for hobby use. Worth joining the Vectric forum as well. You will get a lot of help related to Vectric products on there.
-
Hi Roy and welcome
-
welcome to the boards roy 😀
-
Welcome Roy 😀
Log in to reply.