Home Forums Vinyl Cutter Discussions Graphtec Vinyl Cutters Graphtec cuts from end of design back to origin

  • Graphtec cuts from end of design back to origin

    Posted by Karl.Moss on 13 May 2014 at 16:53

    Hello,

    Just had my new graphtec turn up today, been having a go at trying to cut some vinyl. Have a slight issue, when the cutter is nearly finished it misses the last letter of my design and decides to cut all the way back to the origin where it started.

    Any ideas?

    Thanks in advanced [/i]

    Chris Wool replied 11 years, 4 months ago 3 Members · 3 Replies
  • 3 Replies
  • Alex Parkin

    Member
    13 May 2014 at 17:35

    Is this what you are talking about?

    http://www.uksignboards.com/viewtopic.p … 117#456117

  • Karl.Moss

    Member
    13 May 2014 at 19:18

    Thanks I will have a read up about it

  • Chris Wool

    Member
    14 May 2014 at 08:17

    if the length of the usb cable has no effect.
    dont waist material test with the knife out.
    what software is driving the plotter and did the install load a named graphtec usb port.
    best ring graphtec support nice people should fix over the phone

Log in to reply.