Home › Forums › Vinyl Cutter Discussions › General Cutter topics › Gerber HS-15

  • General Cutter topics

    Gerber HS-15

    Posted by kickn on 10 July 2004 at 13:34

    Hi Everyone I have a tech question if anyone can help. I have a hs-15 that the dip switch under the little access panel got changed i need to know the default or factory settings if any one could help I would be most appreciative. Thanks in advanced. Ken

    kickn replied 21 years, 4 months ago 1 Member · 1 Reply
  • 1 Reply

  • kickn

    Member
    10 July 2004 at 20:58

    its supposed to be the switch that changes the plotter to read between a gerber link cable and a rs-232 cable its on the back of the plotter on the right side

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .