Home › Forums › Software Discussions › Corel Software › Error Message When Using Cutting Master

  • Corel Software

    Error Message When Using Cutting Master

    Posted by Paul Humble on 17 November 2009 at 15:21

    Im halfway through a job and Corel has spat its dummy out on not one, but both my machines.

    Im getting the error message "SACORELCUTPLOT MFC APP HAS STOPPED WORKING"

    Does anyone know what this is? Cutting master appears to start but the window doesnt pop up to send the cut.

    Alan Drury replied 15 years, 11 months ago 3 Members · 3 Replies
  • 3 Replies

  • Chris Wool

    Member
    17 November 2009 at 15:57

    ought to renamed to Cutting Disaster hate the prog with a passion

  • Paul Humble

    Member
    17 November 2009 at 16:42
    quote Chris Wool:

    ought to renamed to Cutting Disaster hate the prog with a passion

    Im set in my ways Chris, im looking at Signlab so all may change soon anyway.

  • Alan Drury

    Member
    17 November 2009 at 16:58

    Can’t say I rate Cutting Master very highly either and compared to the Signlab cutting it is particularly ordinary. I run Corel Draw and Signlab together and they compliment each other very well.
    Alan D

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .