-
does anyone know how to update roland cj500 settings?
I have a problem with the printing on the left head i would like the settings as it looks as though someone has changed the small board on the mother board as there is two the same it may be they did not set it up. dose any one have the set up info from the system setup menu ?
-
2 Replies
-
what settings exactly are you after?
what board changed on the mother board? that machine has no sub boards on the mb itself.the setup from the system menu?
all adjustments are under head adjust, in service menu. the only other "setting" is the head rank associated with that head which will be written on the side of the head.
what problems are you getting?
-
well on the mother board there is two small boards soldered on these are bottom right and just above the two ribbon cables that go up to the heads . the problem i have is on test print it prints 3 boxes and 3 long overlapped box’s . i switched the heads over and it prints 3 box’s and still 3 long overlapped box’s so it is not the head at fault. but as the driver driver is printing something and the little board i was saying has been replaced i wondered if it may have needed setting up or something?
Log in to reply.