Home › Forums › Vinyl Cutter Discussions › Roland Cutters › digiprint parts help please

  • Roland Cutters

    digiprint parts help please

    Posted by Dan Osterbery on 14 February 2013 at 11:40

    Hi All,
    my encoder strip has been cleaned many times and is going barmy again so i might bite the bullet and get a new one! Original part 280€ and a digiprint generic 80€ has anyone tried one do they work well or is it not worth it? Pay the money and get the roland one? any advice greatly appreciated?

    cheers

    Dan

    Gary Birch replied 12 years, 9 months ago 1 Member · 1 Reply
  • 1 Reply

  • Gary Birch

    Member
    14 February 2013 at 12:48

    Hi Dan
    I can’t help with the generic encoder but have you tried turning your strip upside down. We have had one like that for about 3 years on one of our versacamms.

    Cheers

    Gary

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .