Home › Forums › Vinyl Cutter Discussions › General Cutter topics › Corel X3 drivers for my Omega OM60 plotter/cutter.

  • General Cutter topics

    Corel X3 drivers for my Omega OM60 plotter/cutter.

    Posted by Peter Mindham on 15 July 2007 at 18:24

    Hi all
    Does anyone have an idea where I might be able to get drivers to allow me to cut with Corel X3? I am using software supplied with the cutter but to be honest, the support is lacking. Therefore, I want to dispense of the software supplied and change to Corel. Any help orsuggestionss appreciated.

    peter

    Peter Mindham replied 18 years, 2 months ago 2 Members · 2 Replies
  • 2 Replies

  • Chris Wool

    Member
    15 July 2007 at 20:08

    i see the spec says in can accept hpgl so might be tempted to try a roland driver probably esayer to test on lpt1

    chris

  • Peter Mindham

    Member
    15 July 2007 at 21:49

    Thanks Chris,
    This was mentioned to me by another board member last week. I will be trying this week to see if it works.

    Peter

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .