-
coburn 5yr polished silver (chrome) vinyl tips on using it?
Hey all,
i’ve got a job to do with this stuff this week, it’s almost like aluminium foil to the touch !!! have any of you used this stuff before, and do you have any tips on using / cutting it ?
thanks in advance.
Hugh -
6 Replies
-
i have used it in the past, normally good stuff mate.
trying doing some test cuts before proceeding. make sure your blade is nice and sharp too… blunt blades will cause dog earing on the corners of letters etc
never cut loads before weeding. weed while the previous cut stuff is being weeded.. this is not just with theirs, i mean any foils. -
thank you Robert, i’ll have a bit of a tinker tomorrow, though it looks like rain may stop play on thursday when its booked in !!
-
I find you need to raise the blade a couple of clicks. And it is a nightmare to remove after a while
-
you mean cut deeper ? (as you need to with reflective ?)
it’s going on a black backing, so no worries about removal !
-
Cut a lot less deep I’ve found
-
Just wondering on Rob’s comment about weeding…do you do this part way through the cutting process?
If so, can you just pause the cutter? I use a PC600 myself and could pause it by lifting up the cover…is this ok to do?
Log in to reply.