Home › Forums › Sign Making Discussions › General Sign Topics › cnr detail for dibond pan’s

  • General Sign Topics

    cnr detail for dibond pan’s

    Posted by gareth morris on 26 December 2011 at 03:49

    hi,

    first post, long time lurker

    making up some dibond pan’s pans for a fascia above a shop, going to router grove using festool milling saw,

    what is the best cnr detail with folding the sheets up, do you just nip the corner out with cutters after grooving sheet or do you cut in at 45deg angle to fold over.

    thanks in advance

    gareth morris replied 13 years, 9 months ago 2 Members · 2 Replies
  • 2 Replies

  • Ian Johnston

    Member
    26 December 2011 at 20:03

    Just cut the middle of the grove with a sharp blade, you’ll get a perfect mitred corner.

  • gareth morris

    Member
    27 December 2011 at 04:52

    thanks

    any other hints for doing the folding

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .