Home › Forums › Vinyl Cutter Discussions › Graphtec Vinyl Cutters › CE5000-60 Y position alarm

  • Graphtec Vinyl Cutters

    CE5000-60 Y position alarm

    Posted by Ewan Chrystal on 4 January 2013 at 21:41

    Can anyone help me out with what causes this? It’s a backup machine i got with all my new equipment. Turned it on tonight pressed enter and the blade ran right to the left hand side and stopped with the above error message.
    Thanks in advance

    Ewan

    Ewan Chrystal replied 12 years, 9 months ago 3 Members · 5 Replies
  • 5 Replies

  • Harry Cleary

    Member
    4 January 2013 at 22:12

    Are the media clamps in the right position? Lined up somewhere under the blue strips usually

  • Ewan Chrystal

    Member
    4 January 2013 at 22:24

    Will check tomorrow Harry

  • NeilRoss

    Member
    5 January 2013 at 10:19

    Google is your friend:

    http://lmgtfy.com/?q=CE5000-60+Y+position+alarm

    Seems like there are quite a few folk asking this.

  • Ewan Chrystal

    Member
    5 January 2013 at 11:48

    Thanks Neil

  • Ewan Chrystal

    Member
    5 January 2013 at 12:16

    Fixed, thanks a lot guy’s. It was the sensor. I went down the technical route of giving it a wiggle. 🙂

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .