-
CE5000-60 Vinyl pull through after job
Hi,
This may have been mentioned beforehand but does anyone know how to stop the "run off" at the end of a cutting session.
At the end of every job my CE5000-60 will pull though a good couple of metres & then return to the corner at the start of the job! 😕
I am finding I have to wind back the excess unused vinyl back on to the roll!It’s probably a setting, but I don’t know where to find it.
Any help appreciated..
Rick
-
3 Replies
-
What software are you using Rick, will help people explain what you need to do to put it right.
-
just check all setting it will be there somewere.
-
Hi Martin, I’m using Illustrator CS4 (have just invested in CS6 & have installed the latest CM2 drivers but not properly tested it yet).
Log in to reply.