-
Bubbles appearing in prints, thoughts/help?
Hi,
Got a small problem with the first 10mm of prints, It coming out a little bubbly and looking like the inks mixed with water ? Just had the machine converted back to roland with 2 new heads, pump and all the trimmings. Any ideas ?
Dan
mod-edit :police3:
this topic title has now been edited.
please use disriptive topic titles when posting. -
2 Replies
-
If you mean a very small ‘mottled’ kind of look it could be down to being cold. Make sure the heat is up enough and feed some vinyl over the heat and back and try again.
Sorry, only thing I can think of.
G
-
I may be stating the obvious here, but your not using your old profiles from before the conversion? Go to the material manufacturers site and download profiles fresh for your rip/printer setup. This may seem like old rope but I have fixed two customers this week with the same thing.
Hope this helps
Log in to reply.
