Home › Forums › Software Discussions › General Software Topics › AutoCAD??

  • General Software Topics

    AutoCAD??

    Posted by Silvio Alves on 23 December 2005 at 08:18

    Hi Everyone,

    I am back again for some more advise….does anyone know if you can cut directly from AutoCAD? if not is there a way to be able to do this?

    I would also like to take this opportunity in wishing everyone a Merry Christmas and a Prosperous New Year.

    Thank you all to all the advise you have provided throughout the year!!

    :uksbrules:

    Best Wishes

    Silvio

    Silvio Alves replied 19 years, 9 months ago 3 Members · 3 Replies
  • 3 Replies

  • John Childs

    Member
    23 December 2005 at 08:36

    I am not aware of any software that will allow you to cut from Autocad, but perhaps someone else will know for sure.

    When faced with Autocad files I import them into Illustrator and go from there.

  • Nick Minall

    Member
    23 December 2005 at 09:21

    Silvio, you should be able to import DXF into WinCut.

  • Silvio Alves

    Member
    23 December 2005 at 13:03

    Thanks Nick and John

    Will try that out.

    Regards

    Silvio

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .