Home › Forums › Software Discussions › Flexi Sign Software › Anyone using flexi for Gerber Edge? overprint problems

  • Flexi Sign Software

    Anyone using flexi for Gerber Edge? overprint problems

    Posted by Alistair Cunningham on 11 July 2016 at 11:52

    I have a gerber edge LE and i’m using flexi 8.6, when i print a design the printer is printing the overprinted parts of the same colour in a separate pass to the non overprinted parts of the design.
    how do i get them to print in one pass?

    Kevin Flowers replied 9 years, 3 months ago 1 Member · 1 Reply
  • 1 Reply

  • Kevin Flowers

    Member
    11 July 2016 at 17:19

    Think there is a tick box that says ignore over print but its been awhile since i’ve used Flexi

    Kev

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .