-
Advice needed please!
Hi there!
This is my first go on this site so please bear with me!!
I have just been given a Summa D60, it has signlab 7 but no dongle!
Any advice on how to get up and running.
Thank you 😀
-
5 Replies
-
Buy a dongle or cut from coral.
You can download the winplot from the summa website. -
If it’s a genuine version of signlab then cadlink might sell you a dongle for it but it won’t be cheap, Robert paid a lot of money to replace one he had lost.
You might be better off buying a different program like corel to get yourself up and running unless you have deep pockets. -
I just had a replacement dongle for £105 inc VAT. I got mine through simon stanley at lettering systems unlimited.
-
To get a replacement you need the original,
the dongle on its own is in effect the lisence for the program, so it will probably cost the same as a new program 🙁
Peter
-
Ask the person for the SignLab dongle. Perhaps it was merely overlooked and left connected to the previous computer. Most likely it was a USB dongle plugged into back of computer. Otherwise, it would have been a parallel port "pass thru" dongle.
If the person is unable to provide you with dongle, then you’ll need to contact CADlink Sales.
Regards,
Rod at CADlink
Log in to reply.