Home › Forums › Printing Discussions › Roland Printers › Aborting cut program

  • Roland Printers

    Aborting cut program

    Posted by Simon Worrall on 12 September 2013 at 23:27

    HI everyone

    Roland sp540
    If I need to abort a print – registered cut for whatever reason I have to turn off machine at main switch.
    It doesnt respond to pause or anything else I have found once it starts seeking the marks.

    What’s the proper way?

    Simon.

    Cheryl Smith replied 12 years ago 1 Member · 1 Reply
  • 1 Reply

  • Cheryl Smith

    Member
    13 September 2013 at 11:59

    I normally press pause, then pause again to clear on my sp540i…
    you must have an ‘iffy’ button or something Simon… 😕

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .