-
2 plotters – 2 problems – HELP
hi everyone i have 2 plotters
A gerber fastrack 650 – which will not cut the correct size for me i presume this is something small and just a page width setting or something like that could anyone tell me if this would be the problem. I am cutting directly from coreldraw 10.
A roland CM-24 – which for love nor money will not cut edges of letters only tears them have replaced the blade holder that i thought was the problem but no change. Any ideas anyone??
Any help greatly appreciated….
Thanks in advance,
Viv. -
1 Reply
-
ideas
in the driver you could have fit to page turned on.
on some plotters in the menu is a scaling function.
if sized correctly across the plotter but a bit out down the length then calibration.on the roland it still points towards the holder and blade if you can borrow one from any roland to prove a point.
chris
Log in to reply.