• Roland Printers

  SP-540V cutting problem

  Posted by emmezeta150 on 15 October 2025 at 09:31

  Hello to all after long, long time.

  I have an issue with cutting line at my SP-540V. In last few months i noticed that it does not connect the start/end points of cutting line but at the end (or probabbly) start point it makes a little (1 mm) curve instead. That’s very annoying especially on small objects. I changed the knife holder with new original and I use non original knives from Digiprint supplies. I also changed the teflon cutting stripe. Do someone have similar problems?

  emmezeta150 replied 1 day, 8 hours ago 1 Member · 1 Reply
• 1 Reply

• 

  emmezeta150

  Member

  15 October 2025 at 09:34

  And yes, the offset setting is correct.

Log In to Reply