Home › Forums › Vinyl Cutter Discussions › Mimaki Cutters › Servicing a Mimaki CG130 FX

  • Mimaki Cutters

    Servicing a Mimaki CG130 FX

    Posted by Paul Hughes on 18 January 2020 at 21:59

    Anyone able to recommend a decent engineer able to service a Mimaki CG130 FX at a sensible cost who covers the North West? Cheers

    John Lacey replied 5 years, 8 months ago 3 Members · 3 Replies
  • 3 Replies

  • Paul Hughes

    Member
    20 January 2020 at 10:06

    My problems are going from bad to worse now. Any ideas why the carriage should stop working? The cutter switches on and the LCD does what it has to do, but on the last switch on, the carriage is totally lifeless. Is there a small fuse specifically for the carriage or something else I might be missing? All advice and help would be hugely welcome. Thanks again

  • Robert Lambie

    Member
    20 January 2020 at 11:09

    Have you tried Printmax?
    https://www.printmax.co.uk

  • John Lacey

    Member
    20 January 2020 at 14:34

    You have the same cutter as me – mine was supplied by a bloke called Anthony Rinburg about 13 years ago – i’m trying to contact him so i’ll let you know if he’s still about..

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .