-
roland gx640 motor error (20) any ideas
getting a motor error when switching on machine was going fine then switched machine off and switched it back it goes to go to its start position and when aligning itself it hits the right hand side of the machine, tia any help appreciated.
-
10 Replies
-
Have you tried a limit position adjust?
-
Hi Stafford not tried that how do I do that ? Not aware of it lol, thanks
-
Shawn
go back into your XY settings and return them to zero see if that cures issue, could be its trying to go past its home position. If thats the case could just be there’s a sequence to do it etc -
Hi kev I couldn’t get it to go to menu as when I turn it on it try to Initialise first before I can get into menu lol very frustrating I was thinking it may be something to do with that
-
Shawn
you might have it sorted but just a thought you haven’t knocked one of the pinch rollers off of its position have you.
This might help if you don’t have it already
http://support.rolanddga.com/docs/docum … _en_r1.pdf -
hi mate all sorted although i could say how lol but its all good again now cheers mate appreciate all ur help mate,
-
Hi Shawn. I was out of internet most of yesterday. Did Jason call you?
-
hi stafford, yes thanks for that appreciated, id sorted it but not sure how lol. but all up and running, cutter must of had that monday feeling lol. thanks again.
-
Haha, at least it’s running now.
-
lol a lucky escape lol
Log in to reply.