Home › Forums › Printing Discussions › Roland Printers › Blown fuse on main board? Roland sp300v colour issue. Help?

  • Roland Printers

    Blown fuse on main board? Roland sp300v colour issue. Help?

    Posted by Ian Folkson on 18 October 2014 at 21:32

    Ok after all the help I got reading posts and u tube i replaced my black/ Cyan head on my sp300v all by myself and set it up working absolutely perfectly.
    But today some weeks later I did a print perfectly and then sent it again and to my horror no magenta/yellow. Tried pulling through ink and is coming through so checked the fuses on main board F2 and F3
    F3 reading as OK but F2 has a resistance reading. Any ideas if that is the problem or where to look for help.

    Ian

    Ian Folkson replied 10 years, 11 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .