• Off Topic Chat

  Greetings from Plymouth

  Posted by Roy Tebbenham on 2 August 2013 at 04:22

  Hi everyone.

  A quick hello, from Plymouth, I just joined the forum hoping to pick up some tips and learn a bit about milling & engraving. I know nothing at the moment !

  I bought a small CNC machine 200mm x 300m and Aspire software, as a hobby, very small home business. More for mind therapy than profit. I have restricted mobility from a car accident which leads to periods of depression, but I need to keep my mind active. Always look on the bright side of life …tee dum tee dum ..as the song goes 🙂

  Hopefully I can produce signs & plaques as an addition to some wall plaque latex moulds I have for casting green men & other garden plaques from cement & water proof plaster. I did have lots of other larger moulds for garden ornaments but had to sell them, mixing large amounts of cement caused more problems with my back/mobility.

  Hopefully milling & engraving will be less physical and more enjoyable.

  John Harding replied 12 years, 3 months ago 7 Members · 7 Replies
• 7 Replies

• 

  Robert Lambie

  Member

  2 August 2013 at 09:47

  welcome to the boards roy, good to have you here mate…

  a bit of advice, please keep discussion of products etc to relevant forum. you will get more response this way mate.

• 

  John O'Sullivan

  Member

  2 August 2013 at 12:56

  Hi Roy,and welcome to the boards. 🙂

• 

  NeilRoss

  Member

  2 August 2013 at 13:39

  Hi Roy – welcome to UKSB 🙂

• 

  Martin Pearson

  Member

  2 August 2013 at 20:30

  Welcome to the forum Roy, Aspire is an expensive program to buy for hobby use. Worth joining the Vectric forum as well. You will get a lot of help related to Vectric products on there.

• 

  Gary Birch

  Member

  3 August 2013 at 07:11

  Hi Roy and welcome

• 

  Nicola McIntosh

  Member

  12 August 2013 at 14:45

  welcome to the boards roy 😀

• 

  John Harding

  Member

  14 August 2013 at 13:05

  Welcome Roy 😀

Log In to Reply