• Roland Printers

  Printing too dark

  Posted by Craig Cameron on 17 May 2013 at 22:15

  Hi all,

  Doing a wall wrap using self adhesive textile. First wall we used a jpeg image,
  300dpi and 5megabit in size and we blew it up to 8 metres wide by 3 metres high.
  Quality was good and colours were right.

  Now second time round using an image from same source, 300dpi but image is
  Only 1megabit in size. Blew it up to same size again and it’s coming out far too
  Dark.

  I’m printing on an sp540i Using versaworks, genuine inks. Same settings on versaworks. Both images were rgb And first bit of upscaling was done in
  Photoshop and saved as PDFs.

  All I can see is changed is the initial size of the file. Would this alone cause the
  Second print to come out dark. Any advice would be appreciated.

  Robert Lambie replied 12 years, 6 months ago 1 Member · 1 Reply
• 1 Reply

• 

  Robert Lambie

  Member

  18 May 2013 at 17:14

  when you same "from same source" do you mean the exact same file/picture as before? or some place you have purchased an image at same resolution etc, but a new picture?

Log In to Reply