• Graphtec Vinyl Cutters

  CE5000-60 Vinyl pull through after job

  Posted by Rick Hyde on 8 August 2012 at 17:02

  Hi,

  This may have been mentioned beforehand but does anyone know how to stop the "run off" at the end of a cutting session.

  At the end of every job my CE5000-60 will pull though a good couple of metres & then return to the corner at the start of the job! 😕
  I am finding I have to wind back the excess unused vinyl back on to the roll!

  It’s probably a setting, but I don’t know where to find it.

  Any help appreciated..

  Rick

  Rick Hyde replied 13 years, 2 months ago 3 Members · 3 Replies
• 3 Replies

• 

  Martin Pearson

  Member

  8 August 2012 at 17:13

  What software are you using Rick, will help people explain what you need to do to put it right.

• 

  Alex Mc

  Member

  8 August 2012 at 17:54

  just check all setting it will be there somewere.

• 

  Rick Hyde

  Member

  8 August 2012 at 19:09

  Hi Martin, I’m using Illustrator CS4 (have just invested in CS6 & have installed the latest CM2 drivers but not properly tested it yet).

Log In to Reply