• Roland Printers

  Print running at an angle.

  Posted by Martin Oxenham on 17 May 2012 at 19:39

  Just had a friend on the phone who is trying to get a job finished at 8.30 and he says the print is starting to go at an angle. Not the material but the actual print. It is an older Versacamm. Any ideas anyone ?

  Andrew Blackett replied 13 years, 4 months ago 1 Member · 1 Reply
• 1 Reply

• 

  Andrew Blackett

  Member

  17 May 2012 at 19:59

  First check would be gunk on the encoder or fluff in the reader bit. Bend a foam swab and run it (gently) over the encoder strip on both sides to clean it.

  Run environment match and try again.

  Andy

Log In to Reply