-
Roland Soljet 500, print problems, advice please?
Hi All, was hoping someone could advise me as to what my problem might be.
if you look at the attached image there is a white line around the black, blue around the green etc
any help would be great
Thanks
Craigroland soljet 500
:police: Mod-Edit
* Please use "Descriptive Topic Titles" when posting.
* This posts Title has now been edited.Some things HERE you may wish to think about.
Please take a moment to look over our Board Rules.
Attachments:
-
6 Replies
-
The black head has likely had a knock and it’s been whacked out of position at a guess as not familiar with this printer.
Run a set of head alignment tests to be sure.
Dave
-
yellow too…
quite a few out of alignment.headstrikes are the likely cause but thats a big strike
-
what is the gap mm. and how many heads if 2x heads is yellow and mag together.
also is the deformed black bit on the left correct -
What rip are you using? I experienced similar problems and solved it with 2 things…. a full maintenence clean on the heads using cleaning fluid etc (took me a good hour or so to do it properly) wipers, capping stations etc etc (the dragging on the edge of the black gives that away) and also I had my rip profile set to max impact which always messed with the colours especially the whites.
BUT!
2 things more, can you post a copy of the eps file so i can have a test to see if there is something in the file that may be awry and……. what happens on a test print? Full test print and normal nozzle check print? if you could post those here too that may give a better indicationBigMo
-
Thanks for the replys guys.
I had previously posted a thank you but it isnt here!
I take it it was removed as I referred to being on a waiting list with Roland to call me back for 18 months for my last issue.anyway thanks again
Craig:police: Mod-Edit
* Please use "Descriptive Topic Titles" when posting.
* This posts Title has now been edited.Some things HERE you may wish to think about.
Please take a moment to look over our Board Rules.
-
quote Craig Gibson:Thanks for the replys guys.
I had previously posted a thank you but it isnt here!
I take it it was removed as I referred to being on a waiting list with Roland to call me back for 18 months for my last issue.Sorry Craig, but i have just checked.
You have had two posts moved dating back to november 2011.both them broke board rules as you were looking for files and also trying to sell a printer. both in the wrong forum because your membership status did not allow access.
i am not sure what you are insinuating, but if you have a genuine gripe with a supplier, regardless to who the supplier is. your post will NOT be removed.
for the record: we do not delete posts, we simply move them out of sight and can recal any or all if need be.
i hope this clears up any misunderstanding.
best regards
rob
for any further questions, please Contact us here
Log in to reply.