uksignboards.com | SP300 New Pump Help

Roland Printers

SP300 New Pump Help

Posted by Stephen Ingham on 29 September 2011 at 19:56

Hi all, i have just received the new type pump for my SP300 but i could do with a little help if i can please?

It arrived today along with the fitting kit but i am a little confused by it all as there are no instructions and i could do with some if possible or even a diagram showing the position of the brackets etc before i start taking the old one to bits.

Can anyone help please?

Cheers
Stephen

Justin Atkinson replied 14 years ago 5 Members · 9 Replies
9 Replies

Kevin Flowers

Member
29 September 2011 at 21:06

Stephen
not done the conversion on the SP300 but on the Pro2 the bracket allows the pumps to lay flat with the outlets pointing to the capping station. Takes a little figuring out but simple once you realise how it fits

Kev
Stephen Ingham

Member
29 September 2011 at 21:09

Hi Kevin, thanks for the reply.

The other thing is there are the pipe inlet and outlets and they are together so no way of knowing which is which….

I am going to call Tech8 tomorrow where i got it from and ask them…
Kevin Flowers

Member
29 September 2011 at 22:50

David
this should be the pump you have, motor fits underneath & the 2 outlets face the capping stations. You should have a "Y" piece to join the tubes from the capping stations then this fits to the left hand side as you look at the picture the right hand outlet to the waste pipe. Hope this helps

Kev

Attachments:
Stephen Ingham

Member
29 September 2011 at 22:57

Hi Kevin, yes thats the one..
Phill Fenton

Member
30 September 2011 at 08:02

Hi Stephen, the outlet is the one marked "P" with an arrow pointing out. The inlet is marked "S" with an arrow pointing into the pump.
Steve McAdie

Member
30 September 2011 at 10:40

I’ve got the instructions somewhere will dig them out for you. PM you e-mail.

Steve
Stephen Ingham

Member
30 September 2011 at 11:25

Hi guys, thanks for all your help.

I have spoken to tech8 where i got it from and they have emailed me a copy of the installation guide.

Thanks again

Stephen
Stephen Ingham

Member
3 October 2011 at 20:32

Hi Guys, quick update.

I received the installation instructions from Tech8, cheers for that guys.

Installed new pump, a piece of cake and also installed new wipers and scraper whilst i was at it.

Works a treat

Cheers for all you help

Stephen
Justin Atkinson

Member
5 October 2011 at 20:29

Hi Stephen,

Glad you got it all sorted and you received all the correct documentation from us.

I will take note of this and offer this document to everyone who orders these new style Roland pumps.

Always good to get feed back and recommendations.

Thanks,
Justin