-
Problems printing mugs
Just recently bought 2 mug presses done a first run on them fine, went to print another batch and both seem when printed show the elements of the blanket, wondered if anybody else has encountered this and a cure
Cheers
Phil -
4 Replies
-
Hi,
I sometimes get a faint imprint from the surface of the blanket I just put a sheet of paper between the transfer and the blanket. But don’t understand the elements showing problem can you post a pic.
Ian
-
Hi Ian,
I am at home at the moment will try and post a pic on here tomorrow. So your saying put the print onto the mug then another bit of paper on top of that again?? -
hi,
Yes but I only do this if I can see the imprint of the blanket on the mug as the blanket is not perfectly smooth.
or the clamp may be too tight.
Ian
-
quote Phil Green:Just recently bought 2 mug presses done a first run on them fine, went to print another batch and both seem when printed show the elements of the blanket, wondered if anybody else has encountered this and a cure
Cheers
PhilPossibly not enough heat but photos would be needed to confirm. Higher/time temp would cure if this was the cause.
Log in to reply.