uksignboards.com | Van Pricing Enquiry

Job Pricing

Van Pricing Enquiry

Posted by Gareth Hankinson on 2 September 2010 at 17:22

Hi all,

I’m looking for a little help with pricing two off of the van designs attached, one is brand new the other has vinyls to remove and replace.

I’m fine with pricing Mactac 9800 / Oracal 751c / Avery 700 vinyls but ive never had to price using solely Avery 900 series cast which has been specified for the job.

Ive worked out that there needs to be about 14m of vinyl.

I was thinking around £290 + vat each

Any advice appreciated.

Attachments:

Ian Johnston replied 15 years, 1 month ago 7 Members · 9 Replies
9 Replies

Peter Normington

Member
2 September 2010 at 18:03

I would say about right, but depends on how much time you spend on removal and prep of the old van.
Peter
Gareth Hankinson

Member
2 September 2010 at 20:16

Thanks Peter i did think about that as ive not actually seen the older van yet until Saturday…. Ive got the work either way so if im on a good while i will put a bit more on :lol1:

Cheers
Harry Cleary

Member
2 September 2010 at 20:19

Them sticky out bits of vinyl will never last Gareth. 😮 😀 😀
Gareth Hankinson

Member
2 September 2010 at 20:30

ahhh well you see im putting 5mm foamex behind them with a little aerodynamic flap to keep it up……

Bloody design agencies haha (mind the actual artwork wasnt like this i just couldnt be bothered to resave it as a jpeg)
Harry Cleary

Member
2 September 2010 at 20:41

😀
Robert Lambie

Member
2 September 2010 at 23:03

i would say nearer the £400 +vat mate… then hourly rate or fixed price on removal of vinyl as a compromise.
the design isnt hard, but theres a fair bit of cast vinyl and it will need to be a good cast at that.
the job is basically a part wrap… so not a quick fitting.
Rod Gray

Member
3 September 2010 at 09:25

I think £290 is too cheap.

I`d be looking in or around £380.00 + VAT for that mainly due to the wrapping that is required.

Theres a fair amount of obstacles to be considered. Petrol Flaps, handles, number plate lights, badges etc.

Takes a long time to strip them and cutting around them is a no-no.
Cheryl Smith

Member
3 September 2010 at 09:28

Id say Rob has it about right in my book.
Cheryl
Ian Johnston

Member
3 September 2010 at 11:46

quote Robert Lambie:

i would say nearer the £400 +vat mate… then hourly rate or fixed price on removal of vinyl as a compromise.
the design isnt hard, but theres a fair bit of cast vinyl and it will need to be a good cast at that.
the job is basically a part wrap… so not a quick fitting.

That’s the figure i though too maybe even £475 + the removal of the old.

Ian