• Vehicle Wrapping

  Printing to laminate on vehicle graphics

  Posted by Stuart Green on 29 March 2010 at 22:56

  I have been thinking of the best way to remove margins on the wraps. So would this be the right way??

  print panel with reg marks
  (liquid) laminate and leave to dry
  auto align function and cut out the margins.

  or is it better just to manually cut??

  Stuart Green replied 15 years, 6 months ago 3 Members · 6 Replies
• 6 Replies

• 

  Jason Xuereb

  Member

  30 March 2010 at 00:44

  What type of wrap is this?

  Is this a paneled design for a box truck or and you wrapping a passenger vehicle with one piece for the side?

  Paneled design we manually cut with a javelin.

  Passenger vehicle we don’t cut anything. We trim it on the vehicle once applied.

• 

  Stuart Green

  Member

  31 March 2010 at 21:10

  Hi Jason,

  They will be panels, just not sure if i will apply vertically or horizontally yet.

• 

  Jason Xuereb

  Member

  1 April 2010 at 01:02

  Can then manually. Putting them through a plotter for cutting will be time consuming. If the panels are really long then you face the same problems with the plotter versus manually cutting.

  Your going to have any overlap anyways of half to one inch so even if your cutting is slightly off no one is going to notice.

• 

  Stuart Green

  Member

  1 April 2010 at 15:06

  Thanks Jason,

  Really appreciate that!!! 😀

• 

  Chris Rundle

  Member

  1 April 2010 at 15:46

  What width you printing at?

• 

  Stuart Green

  Member

  1 April 2010 at 16:06

  760 WIDTH

Log In to Reply