• CNC Router and Engraving

  Cutters for Intaglio with IS400?

  Posted by Martin Warrow on 11 January 2010 at 18:09

  Hi,

  Suggestions/advice please from anybody out there that uses Intaglio in Gravostyle.

  I’ve just started experimenting with Intaglio and am cutting text into Corian. The results have not been what I was expecting and I put this down to my choice of cutters so far played around with. I am looking for a nice graduated groove but am finding that I get an island effect in the middle of the text. I thought that I would start with a nice easy font "Tahoma Bold" set at 15mm. What do you reckon on the optimum type of cutter for this job?

  Thanks in anticipation.

  Regards

  Mart 😛

  Greg McCarthy replied 13 years, 2 months ago 1 Member · 1 Reply
• 1 Reply

• 

  Greg McCarthy

  Member

  14 July 2012 at 22:51

  Hi Mart,

  I’d recommend using a 1/4 " cutter if you have a collet spindle for the IS400.

  Intaglio works best for larger width cutters

  Greg

Log In to Reply